Superlite Voyager Tent Pitching Instructions

Read the Superlite Voyager tent pitching instructions below:

1. Lay out the inner tent.
2. Carefully assemble each of the 3 poles. Ensure all the joints are fully inserted.
3. Using the diagram below, lay the poles over the inner tent as follows:
   – Pole 1 (blue) diagonally between A and B, making sure the pre-curved section is at the back of the tent.
   – Pole 2 (blue) diagonally between C and D, making sure the pre-curved section is at the back of the tent.
   – Pole 3 (red) between E and F.
4. Insert a pole-end into the outermost eyelet of each inner tent eyelet tape. The tapes are colour-coded to match the relevant pole.
5. Clip the inner tent to the poles.
6. Throw the flysheet over the inner tent.
7. Hook flysheet eyelet tabs to pole end-tips.
8. Insert each pole-end into the corresponding eyelet tape on the hem of the flysheet. The eyelet tapes are colour-coded to match the relevant pole.
9. Peg out the tent.
10. Remember to adjust the flysheet tension as conditions alter (the flysheet will tighten in strong sunlight and slacken if it gets wet).

The Superlite Voyager is supplied with the following:

• 3 x alloy poles (1 x red, 2 x blue)
• 12 x 2g pegs

Superlite Voyager Tent Pitching Video